Raw Mix Proportioning

Raw Mix Proportioning

Accurate data on the chemical composition of raw mix as it is fed to the raw mill can dramatically reduce the cost of production and increase product quality.

Neutron activation cement analyzers are commonly installed in cement mills producing 5000 tons per day of clinker where they are used to control the raw mix bin weighfeeders. Typically, the AllScan cross-belt elemental analyzer is installed on the conveyor upstream of the raw mill and downstream of the feeders where it continuously measures the chemistry of the raw mix.  This data is relayed to specialist raw mix proportioning software that controls dosing from the corrective feeder bins according to pre-defined quality parameters such as LSF.

PGNAA Analyser used in Raw Mix Proportioning
PGNAA Analyser used in Raw Mix Proportioning

This enables the plant to reduce the variability in the raw mix, and ultimately the kiln feed.  Consistent kiln feed chemistry in turn leads to better quality clinker and lower fuel consumption per ton of clinker produced.

The AllScan seamlessly interfaces with well-known raw mix proportioning software such as QCX/Blend Expert™.
Downloads

AllScan PGNAA Raw Mix Proportioning – AllScan® product brochure

Have your application assessed – Application questionnaire

Contact Us

Complete our enquiry form or email us at rti@realtimegrp.com to request further information.

Real Time Instruments | Real Time Group

Enquire Us

Your Name (required)

Your Email (required)

Subject

Your Message